Return to Fast Eddy Bearings Single 5x11x4mm Rubber Sealed Bearing (1)
Sort By::
Page of 1


  0 of 0 people found the following review helpful:
 
5 of 5 buy it December 10, 2023
Reviewer: Anonymous Person  
needed for the coupling bracket by bowhouse for there nr5 skid on any rc4wd tf2 lwb build...you can get all 3 in one shot just add it on..a must part for the best clearence unless you want a hunk  piece of metal on your scale build this is the best option all around..

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Fits and spins nicely July 9, 2023
Reviewer: Drew from Columbia, MO United States  
Fit well, spins nice and smooth. Lasts just as long if not longer than any OEM bearing

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Rolls smooth and cheap October 31, 2018
Reviewer: Joseph De Stefano from Margate, NJ United States  
Cheaper than the axial version, only needed one

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 March 17, 2018
Reviewer: lewis turpin from oklahoma city, OK United States  
great quality bearing

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
3 of 5 February 6, 2018
Reviewer: Dan Hunt from Ukiah, CA United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
1 of 5 Junk bearings January 13, 2018
Reviewer: Sean Meyers from Truckee, CA United States  
These don’t last and are overpriced. The price is not rpp’s fault. Same quality bearings cost half the price on eBay or amazon.



Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 14 for my sawback. January 6, 2018
Reviewer: matthew hoy from lock haven, PA United States  
Replaced all my gmade bearings with these rubber sealed ones. Not sure why but after i did the bearing replacement i put the junfac sawback driveshafts on and had to remove the pinion shaft shims i had on to take the slop out of the pinion spur gears Because the shaft was to short for the driveshaft pins to fit in the pinion spur have no slop anymore either go figure!!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Quick shipping April 14, 2016
Reviewer: Jaden from Bismarck, ND United States  
Quick shipping and the parts arrived packaged very well. The bearings were priced really low so it worked with my budget.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Great and cheap! April 16, 2014
Reviewer: Dave V from Berkeley, CA United States  
I bought 10 of these for a super-cheap price to put in the new RPM front bearing carriers on my HPI Blitz. I was skeptical of the non-metal shields but these have held up well!

Was this review helpful to you?

   
 

Our Friends Say...